Given that my iPad is one of few things I can’t function without, it was about time I gave it the royal treatment. Inspired by Stella McCartney‘s iconic Falabella bag, I whipped up a chain trimmed leather sleeve perfect for my favorite gadget! This tutorial is a great way to learn a super simple hand stitching technique which can also then be applied to other leather wares. Have I piqued your interest yet?
You’ll need:
- leather iPad sleeve
- 30 inches of stainless steel curb chain
- 5 yards of waxed linen cord (last used here & here)
- all purpose rotary punch (last used here)
- an embroidery needle
- wire cutters or bolt cutter (optional)
- scissors
Start by setting the rotary punch to the smallest hole setting. Create a hole in the upper right corner, making sure to punch just outside the seam but without cutting into the outer edge of the leather sleeve. (Click images to enlarge)
Each chain link is approximately 5 millimeters apart, therefore the holes should be spread apart with the same distance. Continue punching holes around the perimeter of the sleeve.
Thread the needle with the waxed linen cord and tie a double knot at the end. Pull the thread through the first hole and pass the needle through the same hole again, making the first stitch.
Pull the needle through the bottom of the first chain link and push it through the top of the second hole. Pull tightly.
Continue pulling the thread through bottom of the next chain link and pushing through the top of the subsequent hole.
Stitch the corner link through the same bottom hole twice.
Tie a double knot to finish the entire stitch. Trim the ends of the knots with scissors and cut away any excess chain with a wire or bolt cutter.
Now go back with fingers or a pair of tweezers to pull out any original broken stitches.
Your Stella McCartney inspired iPad sleeve is finished!
(Stella McCartney Falabella iPad Sleeve $415; all images by HonestlyWTF)
No comments:
Post a Comment